Residential

Filtration Products

Water Well Products

Water Well Accessories

Installation and Electrical Accessories

Sewage Pump Disconnects

Visit our e-stores

Protective Well Enclosure Installation Instructions

Please cut steel banding straps, remove cap using lifting lug. Remove anchor ring. Remove wrench and box of parts. Check box for following items:

  • (3) Concrete anchor bolts
  • (3) Brass flange nuts
  • (1) Tube of concrete sealant caulk
  • (1) Weather resistant Neoprene foam
PWE-Installation-Instructions2 PWE-Installation-Instructions1

Instructions:

Center anchor ring over well cap and place on existing concrete base. Mark and drill (3) 1/2” diameter holes for the anchor bolts. Apply concrete sealer between anchor ring and concrete base. Position anchor ring and install anchor bolts and tighten. Place weather resistant Neoprene foam on top of anchor ring and install base. Install brass flange nuts and tighten using wrench. Please install cap, lock pins, and shielded locks.